Docs

In order to avoid melting/warping, avoid leaving 3D printed items in environments over 55C/131F (e.g. hot car under the sun)

User Instructions:

• Double, Triple Tier
• Switch Break-in Machine 3×3 (V1) v1.4
• Switch Break-in Machine 3×3 RB (V2) v1.1
• Switch Break-in Machine 3×3 DS (V3) v1.0
• Switch Break-in Machine 4×4 (V1) v1.3
• Switch Break-in Machine 4×4 LS (V2) v1.1
• Switch Break-in Machine 4×4 LB (V3) v1.0
• USB Timer/Speed Controller v1.0
• Actuation counter - included at the end of break-in machine instructions

 Acceptable Quality Standards (AQS):

• Single Tier
• Double, Triple Tier
• Switch Break-in Machine
• Plate Support Fork CNC V2

Other Documents:

• Effects of Switch Break-in Machine on Mechanical Switches
• Be advised: The document above, its conclusions, and the experiment outlined within were authored and conducted by Feng Studio, thus raising a conflict of interest. Therefore this document should be used for educational purposes only and not be used to influence your purchasing decision.

Archive:

• Switch Break-in Machine 3×3 Instructions v1
• Switch Break-in Machine 3×3 Instructions v1.1
• Switch Break-in Machine 3×3 Instructions v1.2
• Switch Break-in Machine 3×3 Instructions v1.3
• Switch Break-in Machine 4×4 Instructions v1.0
• Switch Break-in Machine 4×4 Instructions v1.1
• Switch Break-in Machine 4×4 Instructions v1.2
• Switch Break-in Machine 4×4 LS (V2) Instructions v1.0
• Switch Break-in Machine 3×3 RB (V2) Instructions v1.0
• Plate Support Fork AQS
• Plate Support Fork CNC AQS